Limited Space High Performance Antennas Unlike the usual trap antenna, there are no capacitors to break down under high RF voltages. 50 Ohm direct coax feed; tuner usually not required when operating in resonant bands, but may be used for multi-band.  Model DX-CC multi-band 80, 40, 20, 15 and 10 meter dipole • NO-TRAP DESIGN • STAINLESS STEEL • HARDWARE • FULLY ASSEMBLED • SEVERE WEATHER RATED • ALPHA DELTA MANUFACTURED ANTENNAS NOW MADE IN OUR IS0-9001 CERTIFIED PRODUCTION FACILITY.
DX-A - 160-80-40 Meter 1/4-wave Twin Sloper - A top low frequency DX antenna. Combines the tremendous DX firepower of the 1/4-wave sloper with the wide bandwidth of the 1/2-wave dipole. One leg is 67 ft., the other 55 ft. Installs like an Inverted-V with ground return accomplished thru tower or down-lead. DX-B - 1/4-wave DX sloper - A single wire with high performance on 160, 80, 40 & 30 meters. Designed for limited space installations where room doesn't allow for the DX-A twin sloper. Requires only 60 ft. overall and provides amazing DX performance at installation heights of only 35 ft., and with the low end at only 8 ft. Pre-assembled & Pre-tuned. – just put it up and start enjoying low band operation. Utilizes stainless-steel hardware, 12 gauge solid copper wire and efficient Alpha Delta "Iso-Res" RF choke coils. To gain the same broadbanded performance like the DX-A, the DX-B is also designed to be used with a wide range antenna tuner, so no trimming or tweaking is necessary. 50 Ohm coax feed, rated for full legal power. The Models DX-A and DX-B quarter wave slopers require mounting on a grounded tower with an HF size beam on top to act as a "capacity hat". This is necessary for proper tuning and operation. This is not a requirement for half wave dipoles, but unique to quarter wave slopers for transmitting. Instructions For Models DX-A and DX-B DX-SWL - SWL Broadcast Sloper - Covers the 13, 16, 19, 21, 25, 31, 41, 49, 60, 90, and 120M short-wave bands plus the AM broadcast band. Sloper design provides outstanding reception of low-angle DX signals. Multi-band 2KW transmit capability with an appropriate antenna tuner. Overall length is 60 ft.
DX-CC - “No-Trap” 80-40-20-15-10 meter dipole or inverted-V. Overall length is 82 ft. DX-DD - “No-Trap” 80 and 40 meter dipole or inverted-V. Overall length is 82 ft. DX-EE - “No-Trap” 40-20-15-10 meter dipole or inverted V. Also covers 30-17 & 12 meters with an antenna tuner. Overall length is 40 ft.
DX-LB 160M – 20kHz • 80M – 40 kHz • 40M – 300 kHz Full band coverage can be accomplished with an antenna tuner. Built with insulated 12ga. wire, stainless steel hardware and uses the Model DELTA-C static protected center insulator and CIN end insulators. Use coax or open wire line and configure as a dipole or inverted-V. Assembled and ready to go! DX-LB PLUS Directions For Models DX-CC, DD, EE, LB and Plus
DX-ULTRA - Design and construction same as the Model DX-CC, but slightly retuned to favor HF shortwave. DX-Series - Monoband Dipoles Full-size dipoles utilizing the Delta-C Center Insulator with built-in Arc-Plug® Surge Suppressor. Fully assembled using 12 ga. insulated high-strength solid copper wire, CIN end insulators & 50 ft. nylon support rope. Feed with coaxial cable or open-line, rated for legal power.
|
|||||||||
